Honda HR-V Owners & Service Manuals

Honda HR-V: DTC Troubleshooting

READ NEXT:

 DTC Troubleshooting 108-11: Steering Angle Sensor Stuck

NOTE: Before you troubleshoot, review the general troubleshooting information. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTCs with the HDS. Turn the vehicle to the OFF

 DTC Troubleshooting 11-11, 13-11, 15-11, 17-11: Wheel Speed Sensor Circuit Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTC with the HDS. Turn the vehicle to the OFF (

 DTC Troubleshooting 11-12, 13-12, 15-12, 17-12: Wheel Speed Sensor Power Source Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTC with the HDS. Turn the vehicle to the OFF

SEE MORE:

 Immobilizer System Symptom Troubleshooting - Immobilizer Indicator Blinks

NOTE: Before troubleshooting, check the items listed in General Check before Troubleshooting. 1. Immobilizer system check. Connect the HDS to the data link connector (DLC). Turn the vehicle to the ON mode. From the SYSTEM SELECTION MENU, enter IMMOBI, then select IMMOBILIZER SETUP. NOTE: If

 Symptom Troubleshooting

ENGINE LUBRICATION SYSTEM SYMPTOM TROUBLESHOOTING - LOW OIL PRESSURE INDICATOR DOES NOT COME ON WITH THE VEHICLE IN THE ON MODE 1. Input signal test: Connect the HDS to the DLC. Turn the vehicle to the ON mode. Make sure the HDS communicates with the vehicle. If it does not communicate, go to

© 2019-2026 Copyright www.hohrv2.com