Honda HR-V: DTC Troubleshooting 98-11: Seat Belt Buckle Switch Malfunction
NOTE:
- Before you troubleshoot, review the general troubleshooting information.
- VSA will set this DTC if any SRS DTCs exist.
.png)
1. Problem verification:
- Turn the vehicle to the ON mode.
- Clear the DTC with the HDS.
- Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
- Check for DTCs with the HDS.
.png)
Is DTC 98-11 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent
failures troubleshooting.
2. SRS system DTC check:
Check for SRS system DTCs with the HDS.
.png)
Are any DTCs indicated?
YES
Go to indicated DTC's troubleshooting.
NO
Go to step 3.
3. VSA modulator-control unit check (update):
- Update the VSA modulator-control unit if it does not have the latest
software.
- Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
- Check for DTCs with the HDS.
.png)
Is DTC 98-11 indicated?
YES
Check for loose terminals in the VSA modulator-control unit 21P connector. If
the VSA modulator-control
unit was updated and the symptom/indication is still present, replace the VSA
modulator-control
unit.
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the
indicated DTCs troubleshooting.
DTC TROUBLESHOOTING B0050-F0: DRIVER'S SEAT BELT BUCKLE SWITCH MALFUNCTION
NOTE: Before you troubleshoot, review the how to troubleshoot the
electric parking brake system.
.png)
1. Problem verification:
- Turn the vehicle to the ON mode.
- Clear the DTC with the HDS.
- Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
- Check for DTCs with the HDS.
.png)
Is DTC B0050-F0 indicated?
YES
The failure is duplicated. Go to SRS troubleshooting.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent
failures troubleshooting. If the
freeze data/on-board snapshot of this DTC is recorded, try to reproduce the
failure under the same
conditions with the Freeze data/on-board snapshot.
READ NEXT:
NOTE: Before you troubleshoot, review the how to troubleshoot the
electric parking brake system.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the ve
NOTE:
Before you troubleshoot, review the how to troubleshoot the electric
parking brake system.
Before troubleshooting, check the electric parking brake control unit
for proper mounting. If no
NOTE: Before you troubleshoot, review the how to troubleshoot the
electric parking brake system.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the ve
SEE MORE:
Removal & Installation
1. Rear Door Panel - Remove
2. Rear Door Plastic Cover - Remove
Remove the plug cap (A)
Disconnect the connector (B)
Remove the rear door plastic cover (C) as needed.
NOTE : If the plastic
cover is damaged or torn, replace it with a new one.
3. Rear Door Inner Hand
Removal
1. Rear Left Side Trim Panel - Remove - Refer to: Interior Trim
Removal and Installation - Rear Side
Area, or
2. AWD Control Unit - Remove
Turn the vehicle to the OFF (LOCK) mode
Loosen the AWD control unit mounting bolts (A), and remove the AWD
control unit (B)
Disconnect connector (