Honda HR-V: Interior Trim - Service Information
READ NEXT:
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC)
Removal & Installation
1. Center Console Rear Trim - Remove
2. Center Console Armrest - Remove
Remove the screw, then remove the hinge pin (A)
Remove the center console armrest (B).
3. All Re
Removal & Installation
1. Shift Lever Knob - Remove
CVT Models
M/T Models
2. Center Console Switch Trim - Remove
Remove the center console switch trim (A)
Disconnect the connector (B).
3.
SEE MORE:
If you suspect there is an immobilizer system problem, check the status log
in the HDS.
1. Connect the HDS to the data link connector (DLC).
2. Turn the vehicle to the ON mode.
3. On the HDS screen, at SYSTEM SELECTION MENU, enter IMMOBI, then select
IMMOBILIZER SETUP,
select SYSTEM CHECK, NUMBER
MULTIPURPOSE CAMERA AIMING
Special Tools Required
Honda Diagnostic
System (HDS)
MVCI unit with
the latest control
module (CM)
update software
installed
Alignment Set
07AAJ-STKA210
Target Set
07AAK-
5K0A100
Target Adjuster
07AAK-
5K0A110
Stand Pole
(Aluminum)
07AAK-
5K0A120
Stand 07AAJTK8A100