Honda HR-V: Engine Cooling System - Service Information
Honda HR-V (2015-2021) Service Manual / Engine / Engine Cooling System - Service Information
- Coolant Replacement
- Heater Outlet Removal and Installation
- Radiator Removal and Installation
- Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation
- Thermostat Housing Removal and Installation
- Thermostat Removal, Installation, and Test
- Water Outlet Removal and Installation
READ NEXT:
Coolant Replacement
Replacement
1. Radiator Cap - Remove
Wait until the engine is cool, then carefully remove the radiator cap.
2. Engine Undercover - Remove (With Engine Undercover)
3. Engine Coolant - Drain
Loose
Heater Outlet Removal and Installation
Removal and Installation
1. Engine Coolant - Drain
2. Intake Air Duct - Remove
3. Heater Hose and Water Bypass Hose - Disconnect
Disconnect the heater hose (A) and the water bypass hose
(B).
4. H
Radiator Removal and Installation
Removal and Installation
1. Engine Coolant - Drain
2. Engine Undercover - Remove (With Engine Undercover)
3. Lower Radiator Hose and Connector (ECT Sensor 2) - Disconnect
Disconnect the lower radia
SEE MORE:
Interior Trim Removal and Installation - Pillar Areas (With Side Curtain
Airbag)
Removal & Installation
NOTE :
SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC)
and the
precautions and procedures before doing repairs or service.
If side airbags and/or
DTC U128D (MICU) MICU Lost Communication With Gauge Control Module
NOTE : The DTC may be stored due to the grounding failure or the power source
failure at the transmitting
control unit (the grounding inspection and the power source inspection on each
control unit are required prior to
this checking process).
DTC (MICU)
NOTE : If you are troubleshooting multiple
© 2019-2026 Copyright www.hohrv2.com
