Honda HR-V Owners & Service Manuals

Honda HR-V: DTC 1402 Audio Error 2

NOTE:

  • Check the vehicle 12 volt battery condition first.
  • This audio DTC sets when there is a problem with the built-in CD player, or an unplayable disc is inserted.
  • Check that the fan screen on the back of the audio unit is not blocked. Clean it if necessary.
  • If the audio unit displays an error message when you turn on the audio system, follow the instructions.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information.

1. Problem verification:

  1. Check that the temperature is below 158 F (70 C) in the dash.
  2. Clear the hard error codes.
  3. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
  4. Insert a disc into the audio unit, and play the disc, then eject the disc.
  5. Check for hard error codes.

Is DTC 1402 indicated?

YES

The failure is duplicated, go to step 2.

NO

Intermittent failure, the system is OK at this time.

2. Audio disc check:

  1. Clear the hard error codes.
  2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
  3. Insert a known-good disc into the audio unit, and play the disc, then eject the disc.
  4. Check for hard error codes.

Is DTC 1402 indicated?

YES

Replace the audio unit - Refer to: Audio Unit Removal and Installation (Display Audio Type (7-inch Screen), or Audio Unit Removal and Installation (Color Audio Type (5-inch Screen).

NO

Original disc is faulty.

    READ NEXT:

     DTC 1402 Audio Error2 (CD Error)

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when there is a problem with the built-in CD player, or an unplayable disc is inserted. Before you troubleshoot

     DTC 1702 XM Antenna Error

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when there is poor connectors or loose terminals at the XM antenna connector or an open in XM antenna lead. Bef

     DTC 2607 XM Diag

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when a problem (open or short) is detected in the GA-Net BUS (the XM icon is red in the System Links). Before y

    SEE MORE:

     Speed Dial

    Up to 20 speed dial numbers can be stored per phone. To store a speed dial number: 1. Go to the Phone menu screen. 2. Select Speed Dial. Repeat the procedure to select New Entry. 3. Select a place to choose a number. From Import from Call History: Select a number from the call history. From

     Under-Dash Fuse/Relay Box Removal and Installation

    Special Tools Required Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0 Removal NOTE: SRS components are located in this area. Review the SRS component locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the precautions and procedures before do

    © 2019-2025 Copyright www.hohrv2.com