Honda HR-V: Opening and Closing the Windows
Opening/Closing the Power Windows
The power windows can be opened and closed when the ignition switch is in ON (II)*1, using the switches on the doors. The driver's side switches can be used to open and close all of the windows.
The power window lock button on the driver's side must be switched off (not pushed in, indicator off) to open and close the windows from anywhere other than the driver's seat.
When the power window lock button is pushed in, the indicator comes on and you can only operate the driver's window. Turn the power window lock button on when children are in the vehicle.
WARNING
Closing a power window on someone's hands or fingers can cause serious injury.
Make sure your passengers are away from the windows before closing them.
The power windows can be operated for up to 10 minutes after you turn the ignition switch to LOCK (0)*1. Opening either front door cancels this function.
Auto Reverse
If a power window senses resistance when closing automatically, it will stop closing and reverse direction.
The driver's window auto reverse function is disabled when you continuously pull up the switch.
The auto reverse function stops sensing when the window is almost closed to ensure that it fully closes.
■Opening/Closing Windows with Auto-Open/Close Function
■ Automatic operation
To open: Push the switch down firmly.
To close: Pull the switch up firmly.
The window opens or closes completely. To stop the window at any time, push or pull the switch briefly.
■ Manual operation
To open: Push the switch down lightly, and hold it until the desired position is reached.
To close: Pull the switch up lightly, and hold it until the desired position is reached.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
■Opening/Closing Windows without Auto-Open/Close Function
To open: Push the switch down lightly, and hold it until the desired position is reached.
To close: Pull the switch up lightly, and hold it until the desired position is reached.
READ NEXT:
Opening and Closing the Moonroof
■Opening/Closing the Moonroof
You can only operate the moonroof when the ignition switch is in ON (II)*1.
Use the
switch in the front of the ceiling to open and close the moonroof.
■ Automatic o
Ignition Switch
Models without smart entry system
Manual transmission models
WARNING
Removing the key from the ignition switch
while driving locks the steering. This can
cause you to lose control of the vehicle.
Re
SEE MORE:
DTC U0402-68 TCM Malfunction
NOTE : Before you troubleshoot, review the how to troubleshoot information -
Refer to: How to Troubleshoot
the Forward Collision Warning (FCW), or How to Troubleshoot the Lane Departure
Warning (LDW).
DTCs (FCW/LDW)
1. Problem verification.
Turn the vehicle to the ON mode.
Clear the DTC with t
Security System
Immobilizer System
The immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use
electronic
signals to verify the key.
Pay attention to the following when inserting the key into the ignition switch
or
pressing t
