Honda HR-V: Mirrors - Testing & Troubleshooting
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Mirrors - Testing & Troubleshooting
READ NEXT:
Description
AUTOMATIC DIMMING MIRRORS SYSTEM DESCRIPTION - CONTROL/FUNCTION
When the automatic dimming off button is turned ON, the control unit receives
signals from each sensor. Based
on the difference between
Automatic Dimming Mirrors Test
1. Turn the vehicle to the OFF (LOCK) mode
2. Disconnect the automatic dimming inside mirror 7P connector.
3. Check for continuity between terminal No. 6 and body ground.
If there is continuity, go
SEE MORE:
DTC Troubleshooting 52-11: Motor Stuck OFF
NOTE: Before you troubleshoot, review the general troubleshooting
information.
DTCs (VSA)
1. Solenoid operation check:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
Operate any one of the four solenoids in the VSA FU
DTC U0100, U0122, U0128, U0131, U0151 (Gauge Control Module)
NOTE:
Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on the
instructions in the table below.
The DTC may be stored due to the grounding failure or the power source
failure at the transmitting
control unit (the grounding inspection and the pow
© 2019-2026 Copyright www.hohrv2.com
