Honda HR-V: Exterior Lighting - Service Information
READ NEXT:
Removal & Installation
1. Automatic Lighting Control Unit-Sensor - Remove
Pull out the automatic lighting control unit-sensor (A).
NOTE : Be careful not
to damage the automatic lighting contr
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component
Location Index (KA/KC
Removal & Installation
Headlight (High/Low)
1. Headlight Bulb - Remove
Disconnect the connector (A)
Remove the rubber (B).
Pull the retaning spring (A) away from the bulb (B), then
remove
SEE MORE:
Special Tools Required
SRS Inflator Simulator 07SAZ-TB4011A
SRS Simulator Lead J 070AZ-SNAA100
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct par
FUEL LINE/QUICK-CONNECT FITTING PRECAUTIONS (KA/KC)
The fuel line/quick-connect fittings (A to I) connect following:
A: fuel feed hose (J) to fuel rail (K), fuel feed hose (J) to fuel line
(L)
B: fuel tank unit (M) to fuel line (N)
C: fuel tank unit (M) to fuel suction line (O)
D: fuel tank u