Honda HR-V Owners & Service Manuals

Honda HR-V: Replacing Light Bulbs

READ NEXT:

 Headlight Bulbs

When replacing, use the following bulbs. High/Low beam headlight: 60/55 W (HB2 for halogen bulb type) ■High/Low Beam Headlight 1. Remove the coupler. 2. Remove the rubber weather seal. 3. Remove t

 Rear Turn Signal Light Bulbs

When replacing, use the following bulbs. Rear Turn Signal Light: 21 W (Amber) 1. Use a Phillips-head screwdriver to remove the bolts. 2. Pull the light assembly out of the rear pillar. 3. Turn the s

 Checking and Maintaining Wiper Blades

Checking Wiper Blades If the wiper blade rubber has deteriorated, it will leave streaks and the hard surfaces of the blade may scratch the window glass. Changing the Front Wiper Blade Rubber 1. Lift

SEE MORE:

 DTC Troubleshooting 54-11, 54-12: Fail-Safe Relay Stuck

NOTE: Before you troubleshoot, review the general troubleshooting information. 1. Problem verification: Turn the vehicle to the ON mode. Clear the DTC with the HDS. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode. Check for DTCs with the HDS. Is DTC 54-11 or 54-12 indicated? YE

 PCM Removal and Installation

Removal NOTE: Make sure the HDS or the MVCI has the latest HDS software version. If you are replacing the PCM after substituting a known-good PCM, reinstall the original PCM, then do this procedure. If you are removing or substituting the PCM, skip the procedures of READ DATA (Engine Oil Li

© 2019-2026 Copyright www.hohrv2.com