Honda HR-V: Is a Lab Scope Necessary?
READ NEXT:
INTRODUCTION
You probably have several tools at your disposal to diagnose injector
circuits. But you might have questioned
"Is a lab scope necessary to do a thorough job, or will a set of noid lights
A DVOM is typically used to check injector resistance and available voltage
at the injector. Some techs also use
it check injector on-time either with a built-in feature or by using the
dwell/duty f
NOTE: This is GENERAL information. This article is not intended to be
specific to any
unique situation or individual vehicle configuration. For model-specific
information see appropriate a rtic
SEE MORE:
Test
Driver's door
1. Driver's Door Panel - Remove
2. Driver's Door Lock Knob Switch - Test
Disconnect the connector (A).
Check for continuity between the terminals in each
switch position according to the table.
If the continuity is not as specified, the driver's door lock
knob switch is fa
Removal & Installation
1. Rear Accessory Power Socket - Remove
Gently press the tabs (A), and remove the rear accessory
power socket (B)
Disconnect the connector.
Gently press the tabs (A), and remove the housing (B) from the right
rear
side trim panel. Note the location of the index