Honda HR-V: DTC Troubleshooting
READ NEXT:
TESTING
AWD CONTROL UNIT INITIALIZATION (AWD)
Procedure
NOTE:
Whenever the AWD control unit is replaced, it must be initialized.
Park the vehicle on a flat and level surface.
1. HDS - Connect
2.
Test
1. HDS - Connect
2. Rear Differential Clutch - Test
Block the front wheels (A), raise the left rear wheel, and support it
with a safety stand (B) as shown
Release the parking brake.
Hold
Test
NOTE: Before doing the pressure test, check the following conditions.
Check that the AWD system indicator does not come on. If it does, check
for AWD with intelligent control system DTCs.
Che
SEE MORE:
Inspection
1. Differential Backlash - Inspect
Place the differential assembly on V-blocks (A), and install the
intermediate shaft
(B) and the left driveshaft (C)
Measure the backlash of both pinion gears (D) with a dial indicator (E).
If the
backlash is not within the standard, check the d
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component
Location Index (KA/KC) and the precautions
and procedures before doing repairs or service.
1. Column Cover - Remove
2. Co