Honda HR-V: Bluetooth HandsFreeLink (Models with display audio system)
To use HFL, you need a Bluetooth-compatible cell phone. For a list of compatible phones, pairing procedures, and special feature capabilities:
- U.S.: Visit www.handsfreelink.honda.com, or call 1-888-528 -7876.
- Canada: Visit www.handsfreelink.ca, or call 1-888- 528-7876.
To use HFL, the Bluetooth On/Off Status setting must be On.
Voice control tips
- Press and release the button when you want to call a number using a stored voice tag, a phonebook, name or a number. Speak clearly and naturally after a beep
- If the microphone picks up voices other than yours, the command may be misinterpreted.
- To change the volume level, use the audio system's VOL (Volume) or use the remote audio controls on the steering wheel.
State or local laws may prohibit the operation of handheld electronic devices while operating a vehicle.
Up to six speed dial entries can be displayed among a total of 20 that can be entered. If there is no entries in the system, Speed Dial is disabled.
Bluetooth Wireless Technology
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Honda Motor Co., Ltd., is under license. Other trademarks and trade names are those of their respective owners.
HFL Limitations
An incoming call on HFL will interrupt the audio system when it is playing. It will resume when the call is ended.
Models with navigation system
See the navigation system manual for how to operate the Bluetooth HandsFreeLink.
Models without navigation system
Bluetooth HandsFreeLink (HFL) allows you to place and receive phone calls using your vehicle's audio system, without handling your cell phone.
- Using HFL
- HFL Menus
- Phone Setup
- To Set Up a Text/E-mail Message Options
- Speed Dial
- Making a Call
- Receiving a Text/E-mail Message
- In Case of Emergency
READ NEXT:
Using HFL
■HFL Buttons
(Pick-up) button: Press to go
directly to the Phone screen, or to answer an
incoming call.
(Hang-up/Back) button: Press
to end a call, go back to the previous
command, or to cancel
HFL Menus
The ignition switch must be in ACCESSORY (I) or ON (II)*1 to use HFL.
To use HFL, you must first pair your Bluetoothcompatible
mobile phone to the system while the
vehicle is parked.
Some functions a
Phone Setup
■ To pair a mobile phone (when there is
no phone paired to the system)
1. Select Phone.
2. Select Yes.
3. Make sure your phone is in search or
discoverable mode, then select OK.
HFL automatically
SEE MORE:
DTC Troubleshooting 68-12: Brake Pedal Position Switch Stuck ON
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. VSA modulator-control unit performance check:
Start the engine.
Check the parameter(s) below with the HDS. Do not press the brake pedal.
Is there 10 MPa or more?
YES
Go to step 2.
NO
Go to step 3.
2. Brake pedal
DTC Troubleshooting B0082-1A: Decreased Resistance in the Selectable Energy
Absorption Device of the Front Passenger's Seat Belt Tensioner
Special Tools Required
SRS Short Canceller 070AZ-SAA0100
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly ins
