Honda HR-V: Testing
- A/C Diagnostic Process
- Air Mix Control Motor/Mode Control Motor/Recirculation Control Motor Test
- Blower Power Transistor Test
- Heater Fan Switch Test
READ NEXT:
A/C Diagnostic Process
When a customer presents an A/C concern, do the following procedure to
identify the cause of the problem.
1. Confirm the type of concern.
If a customer complains about an A/C performance problem, g
Air Mix Control Motor/Mode Control Motor/Recirculation Control Motor Test
Special Tools Required
Backprobe Set 07SAZ-
001000A
Test
SRS components are located near the mode control motor and the recirculation
control motor. Review the SRS
component locations - Refer to: SR
Blower Power Transistor Test
Test
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the
precautions and
pro
SEE MORE:
Disassembly and Reassembly
STEERING GEARBOX DISASSEMBLY AND REASSEMBLY
Exploded View
NOTE:
For these operations, refer to the complete procedure as needed.
Rack end removal and installation
Rack guide adjustment
Tie-rod end ball joint boot replacement
If the rack guide is removed, rack guide adjustment is necessary.
DTC B1646, B1648, B1660, B1664 Antenna Circuit Open
NOTE: Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Keyless Access Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to
follow the instructions in B-CAN System Diagnosis Test Mode A
© 2019-2026 Copyright www.hohrv2.com
